Air Lift Mechanism, Model 109 3 Position Freearm, Flatbed
Our electric lift is strong (up to 75 pound capacity*), easy to use and effortless at the touch of a switch. The new optional Auto-Stop feature makes using the lift even easier and extends the warranty to 5 years. Preset the lift to stop at the flatbed position where you would use an insert to fill the void and it will stop at that level perfectly everytime, eliminating the hassle of running it up and down until you hit the right spot. Then if you want to use your machine in the free-arm position you simply hold the bypass switch and press the rocker switch to go up until the unit stops again by itself.
Shown left and right is the current structure of the lift but the wiring is now a separate power pack that attaches to the switch.
Use a petrolium jelly such as Vaseline® to coat the exposed metal to prevent rust and keep the operation of the lift quiet. Never allow your lift to slam into the top or bottom of travel for longer service (Auto-Stop v2.0 prevents this). Check the condition and movement of cords for wear, cracking and freedom of movement.
The electric lift is warranted for one (1) year parts and labor on electrical and moving parts; i.e. power pack, motor assembly, gear and rack, cable, switches and bearings. The addition of the Auto-Stop feature doubles the warranty to five (5) years. Warranty is void if lift is misused. Lift mechanisms should be inspected for wear, alignment and function at least yearly and maintained accordingly to prevent failure. A failure of the lift could result in a vertical fall. Failure to maintain proper function of your lift may result in other damages for which we are not responsible.
- Life of lift diminishes slightly with increased load and frequency of use, which cause increased wear on parts.
The Standard Height of the lift is 23 3/4" with a total travel of 17.25" but can be customized to heights from about 19" on up and may cost a little extra for the customization but depends on a case by case basis.
The "wings" or platform supports can be adjusted width wise but excessive bending may damage the powder coating. They typically measure 17.75 to 18" from front tip to front tip. From the back of the mounting bracket to the first edge is 3" and to the front tip is 11".
The Mounting Brackets top and bottom are 11 3/8" wide by 2 3/16" deep at the top and bottom with a back mount flange that comes down 7/8". There are three 3/16" holes across the mounting brackets on each top, bottom and the back flanges (exception: the middle holes on the back flanges are 1/4") measuring from the sides are 1/2" and the middle hole 5 11/16". The top and bottom holes are 1 7/16" from the back and the flange holes are 9/16" from the top or bottom per case.
Electrical cord consists of a C-13 typically, C-5 or C-7 connector to US NEMA 5-15P plug